Lanzar OPTIXA6B User Manual download pdf (Page 6)

Connect the Power terminal of the crossover to the car’s *battery.

Use a 16 gauge wire to connect to the terminal on the crossover marked + 12V. Run the wire

directly to the positive terminal of the car’s *battery. Make sure to use an in-line fuse (1 amp)

within 12’’ of the battery.*Since the crossover’s current draw is nominal, you can connect to the

pre-existing +12V power wire that has been run for the crossovers if so desired.

Connect the ground terminal of the crossover to the car’s chassis

Use a 16 gauge wire to connect the GROUND terminal to the car’s chassis .Try to keep the

length of the cable as short as possible , preferably less than 12’’, Also make sure that the point

on the car chassis where the connection is to be made is free of paint and dirt .It is

recommended to grounding point as the amplifiers to eliminate the possibility of ground loop

(engine noise )caused by different levels of ground to each of the components .

Connect the remote terminal of the crossover to a switchable +12V

This connection allows the crossover to be turned on and off with the power control of the head

unit .If the head unit has a PEMOTE OUTPUT WIRE (+12V), connect it to the OPTIXA6B

terminal marked REM .Now when the head unit is turned on, the crossover will automatically

turn on, If the head unit does not provide a remote output, it is necessary to connect the

crossover to switched +12V power supply (when the car is on or in use).

IMPORTANT!

Before making any connection, disconnect the car’s battery until the installation is

completed to avoid possible damage to the electrical system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Lanzar OPTIXA6B User Manual Page 6